ZUGO PAS Sensor Cable

HOW TO INSTALL: This guide will take us through the replacement of the PAS sensor. If you received the part just to test, remember it’s much easier just to “outboard” the cable before running it through the frame! The first step is to take your Phillips screwdriver and remove the two screws on the bottom of the bike holding the PAS onto the frame. Simply unscrew by turning both of the screws counter-clockwise. We remove the screws because the mount is installed behind the bottom bracket cup and it’s much easier to replace this way. Keep the two screws if you want, but most likely your new PAS came with two more replacement screws. Not a bad idea to toss these into your toolkit though Pull the sensor away from the bracket, the small red light need to be backed out of the hole. You might need to push the ring of magnets away. Using the 13mm provided in your toolkit, remove the 5 bolts located underneath the seat by turning them counterclockwise. There are 5 12mm nuts underneath that need to be removed. Cut the zipties that hold together the bundle by the controller. Unplug the 3 pin Julet PAS cable from the controller bundle, it will be yellow. With the sensor disconnected from…